Business
Electrical circuits often use the terms switchgear and switchboard. Electrical contractors need to understand both terms in order to communicate well with their peers. There are many switchgear companies. Therefore, it is very important to understand these two terms correctly to choose the best switchgear supplier.
Whatoop is a professional MCC panel manufacturer, the following information they provide can help you differentiate between switchgear and switchboards.
Tip 1: Definition
A switchgear is a component or combination of electrical devices used to isolate or protect electrical circuits. Switchgear uses include automatically turning off and turning on the power in electrical systems, allowing electricians to break circuits for repairs, and monitoring electrical systems.
Switchboards are electrical control assemblies with switches, circuit breakers, low voltage capacitor and fuses used to distribute electricity in a building. Switchboard assemblies may also include gauges, relays, and other electrical control and protection devices.
Tip 2: Design
The main difference between a switchgear and a switchboard is the design of the parts. Switchgear assemblies consist of serviceable withdrawable (full or partial) circuit breakers that have solid insulation to protect them from other parts.
Since there are many circuits in the switchgear, a good design can prevent the circuits from affecting each other and avoid malfunctions. For example, the plc panel manufacturer will also refer to the design of the switchgear to promote the coordination between various electrical components.
Switchboard breakers, on the other hand, are usually bolted to the bus and are separated from other components only by air. This design makes the switchboard smaller but also means that the circuit breakers cannot be repaired, only replaced.
It is also worth noting that switchgear often uses a rear compartment for cable termination. With front terminals, switchboards are wall-mountable and smaller than switchgear.
Tip 3: Voltage
Voltage rating is another major difference between switchgear and switchboards. Switchgear is rated for a wider range of voltages, ranging from a few volts to thousands of volts. For example, the voltage range of low voltage switchgear can reach 1kv, while the voltage range of medium and high-voltage switchgear can reach 366kv and higher.
Electrical switchboards, on the other hand, are designed for lower voltages, usually below 600 V. For example, a typical residential switchboard is rated for 120/240 V. On the other hand, commercial and industrial facilities may have switchboards rated up to 600 volts.
Tip 4: Standards and tests
Both devices are 2200-volt dielectric circuits and are tested slightly differently.
The high-voltage switchgear is a long-circuit structure with a power factor of 15% capacity and 30 cycles. On the other hand, the switchboard is a short-circuit structure with a power factor of 20% and 3 cycles. It is used in insulated case circuit breakers and molded case circuit breakers according to NEMA PB-2 and UL-891 standards.
Tip 5: Size
The switchboard takes up less space and works primarily in front access. They are ideal for small electrical systems.
However, switchgear is different because they gain front and rear access in the event of a cable break. They take up more space and are ideal for developing larger circuits. It is like an electrical cabinet, which can include VFD control panel, plc panel, etc.
Tip 6: Arc safety
Arc-containing switchgear uses more elaborate insulation methods such as air, gas, oil, solid dielectric, or even vacuum. In switchboards, some of these arc flash extinguishing techniques may not exist because they are not industry standard requirements.
You can find out more on our website - https://www.whatoop.com/